Same here.. still adjusting. Amp is an Orange Rocker 15. I got some new cables recently and was able to re-order things to try and get pedals that I want to hit while playing down on the bottom row. I've also been re-ordering to try and preserve sound quality. I use the FX loop, so the order is actually like this: Guitar -> Fur Coat (Fuzz) -> Two Stroke (Boost/EQ) -> Hum Debugger -> Kongpressor (Compressor) -> Polytune -> Amp FX loop is: Memory Boy -> Polara (Reverb) -> TR-2 Tremolo -> Beat Buddy -> Ditto. I can use the Memory Boy for chorus/vibrato without delay if need be. I wanted the Memory boy on the right side as the FX Send goes into it and where it is located I can use the expression pedal jack too. All pedals with lines to the amp are on the edge right now so I can plug/unplug it fast if I want to. Foot switch is just in there to switch channels, maybe it should be down on the bottom row to. I use the beat buddy + ditto a lot practicing and really wanted to get those down on the bottom row. I've kind of come to the realization OD/Distortion pedals are just silly with my amp, focusing on boosting + fuzz which work well with low headroom amps/dirty channels. Might lose the Hum Debugger and try to figure out if there is something else like a Phaser or modulation effect I could benefit from. That's a low priority thing though. Getting rid of that would get rid of the need for a separate power supply.. the Hum Debugger is the only thing on here that can't use the board power.