Please correct this diagram

Discussion in 'Tele Home Depot' started by Art VanDelay, Jan 18, 2020.

  1. Art VanDelay

    Art VanDelay Tele-Afflicted

    Posts:
    1,132
    Joined:
    May 20, 2018
    Location:
    Arcata
    So I recently decided to do a Spring cleaning of sorts on my Tele partscaster because my first wiring job was sloppy (WAY too much excess wire...drove me nuts). So below is a diagram of my 4-way selector switch as I currently have it wired.

    I should also add that I have TWO tones and TWO volumes (in the form of concentric pots), not the traditional set-up.

    I get both volume and tone from first 3 positions, but the 4th position (both pickups wired in SERIES) is dead silent.

    Where am I going wrong?

    Switch Snip.JPG
     
IMPORTANT: Treat everyone here with respect, no matter how difficult!
No sex, drug, political, religion or hate discussion permitted here.


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.