P-rails "Esquire" wiring diagram.

[dud77]

Hi, I'm modding a tele i made a few years ago. I want to put a single P-rails in bridge. I'd like to wire it with a 4-way switch to have p90/rails/humbucker parallel/ humbucker séries. A push pull pot is in place yet. Maybe could i use it with a 3-way switch with p90/rail/humbucker and the push-pull for parallel/ series.
I've very poor skills on wiring design, so If one you could give a wiring schematic it would be great.

 

[thaynes]

I found this thread researching a different issue with the Eldred mod. Maybe you can find something that will work for your situation.

Esquire Teles | GuitarNutz 2

Foreword

guitarnuts2.proboards.com

Good luck!!


Tom.

 

[dogmeat]

get the Triple Shot bezel from duncan. it has micro switches to set the P-Rail for most possibilities. or... get a rotary switch. I have experimented with 'Rails quite a bit. rotaries will give you anything you want

 

[dud77]

get the Triple Shot bezel from duncan. it has micro switches to set the P-Rail for most possibilities. or... get a rotary switch. I have experimented with 'Rails quite a bit. rotaries will give you anything you wantBut it doesn't fit tele bridge

It doesn't fit tele bridge, does it?

I found this thread researching a different issue with the Eldred mod. Maybe you can find something that will work for your situation.

Esquire Teles | GuitarNutz 2

Foreword

guitarnuts2.proboards.com

Good luck!!


Tom.

Thanks, i found one.