Separate names with a comma.
Discussion in 'The DIY Tool Shed' started by jkingma, Apr 24, 2020.
For a lower cost CNC, you'll do much better with a Shapeoko XL or XXL than with the Shark, IMHO.
Here's one (Delta/Onsrud) that might interest you John -
It's just across the border, but wouldn't be far from you.
And you are only a couple miles from a Bocce Club Pizza!
I don't know anything about Bocce Pizza, but that pin router is only about 200 miles from where John is at !
An afternoon jaunt for some of us .
edit: I'm kinda partial to Antonio's with sausage, roasted red peppers and onion .
My brother used to live in Lockport for a while. The old erie canal has a bunch of locks there as it is right on what's called the Escarpment where the land drops down to Lake Ontario. It runs through CA and through NY state.
The border is closed to Non Essential traffic.
I actually think when the time comes I will go the CNC route anyway.