Separate names with a comma.
Discussion in 'Tele Home Depot' started by papaschtroumpf, Jun 22, 2017.
I used a cove bit on this guitar, and I was pretty happy with the proportions.
Still working on this project, getting close. Here is a pic of the German carve.
Happy with the results of that cabinet bit.
I'd say that's a beautiful carve. Well done, old boy.
Here's one way I did it.
These other pictures are further pages down in the thread. Show how it turned out:
It's "German-ish" but a bit curvier. All cut on the router table though except for some hand carving in the cutaway.
I'm really liking this 'carve' you've done.
The outside edge is sharp enough for a binding.
Just wondering out loud how it would be possible with the simple tools I have.
I bought the same control plate and bridge too. Havent done anything yet
Did you do the back too?
No front only
I haven't decided whether to use the plate with the switch in this position or reverse. The bridge and plate were pretty cheap. This whole project was supposed to be done on the cheap
I'm a cheapskate