Guitar Paul

NEW MEMBER!
Joined
May 13, 2022
Posts
2
Age
58
Location
USA
I have not found an answer for this. I have a tele with 1 single coil (neck) and 1 humbucker (bridge). There was no wiring, so I am now wiring this up. I have followed a diagram that seemed correct, however when I flip the 3 way, the humbucker is always hot, when it should be off when the selector opts for the neck.

This is what I have used: (FYI red represents the lead or hot wire)
1 single-1humbucker-2vol-1tone-3waytoggle.jpg


I have swapped location of the poles from pickup and three way, nothing works.

Also seems the single coil is barely audible..

This guitar is not wired yet.

Any direction/diagrams are greatly appreciated.
 
Last edited:




Top