Separate names with a comma.
Went to a 12” speaker with oxblood cloth.
Found on ebay
How come you have .022uf on intensity pot? Normally its .047.
Thank you. I’ll try that. I had to order some caps. As soon as they come in ill open it up again.
Amp sounds good i do get the tremolo thump that I may address sometime.
All voltages look good and amp is assembled. Heres a look
The bias pot i used 2 38k resistors in parralel and a 10k pot and I end up right in the middle of the pot range.
The 662 is alive. I had a squeal which i just remedied by swapping blue and brown off the hammond 1750e OT. Here are some of the voltages
99% wired. I hope to have done either tomorrow or Saturday.
Got little bit more wired tonight
Thank you where i work we powder coat machines and 1 of our colors is traffic black which is a perfect satin black for these types of things.
Got some wiring done
Thank you. Heres front
Probably gonna use these pot labels
Got front panel layed out today.
I spun the sozos around too
Everything fits ok
Test fit in cabinet
I could spin the caps around. The yellow caps had a red line on them indicating foil. I wasn’t sure about the sozos. Thank you
I stood it up so I could get the bias board to fit better. Probably should’ve laid it down. What is the preferred guideline for transformer...
No i have not
I will have a 10k bias adjust that is not installed yet. I converted a laydown transformer to stand up in order to make more room inside the...
I had built a vibrochamp with a mather cabinet that was taller than stock with a 10”. I got the urge to do a 6g2. So i decided to make it fit the...
Did a rough setup. Played a few cowboy chords through my vibro champ