Separate names with a comma.
thank you, everyone, the cab is sturdy. I guess I will just bolt the speaker to the front. I am considering using the Weber Alnico Signature 8...
I am going to cover the speaker hole with grill cloth on the inside.
here is the photo
I thought it would be fun to build the champ micro in a small cab with an 8-inch speaker and have it look a bit vintage radio so I found...
thanks, I saw something that said that putting the wires with the white stripe with the white is just a good way to keep things straight.
I did a little research and I think the black/white and brown/white go to the white neutral power cord wire and the black and brown go to the...
thanks all. I just found a 40-18027 for a really good price. I understand the red and green and red/yellow and green/yellow wires for use in the...
Thanks, I am planning to ditch the tube rectifier.
would it be fine to use the 40-18019 rather than the 40-18027?
They seem quite similar, the only difference I see is the red wires in the 19...
thanks for the help, I am leaning toward the ClassicTone now. I can read and understand some of the Hammond diagram but with my level of knowledge...
starting my planning for the champ micro and found that with shipping the Hammond is about $30 cheaper and Rob says it works well.
I know how...
thanks, that's a good idea
thanks, just what I wanted to hear
I am considering getting an aluminum chassis but I am wondering if you can ground to it with a solder lug and screw or bolt? is there anything...
what is the length and the height of the chassis? 10" by 2"?
thanks will do that
still distortion, I did try my humucker on a tele and it does break up a little at very high volume.
thanks for the responses. I looked at it late last night and found that my 12ax7 and 12ay7 were switch so I switched them and then took voltages...
resoldering points, did that bring your v2 7 pin up from 3 to where it should be at around 18 - 20?
this is a strange coincidence I have about 3 volts at 7 and all the resistors test correct and at 8 I have 47 volts, same as you. My problem is...
I just built a 5e3 and cannot get it to distort, only get louder and clean.
I think that a few of my voltages are a bit low and some high for V1...
I really like your homemade chassis (oriented toward the back not up like Fender and like the wood cab.
I am putting the above-mentioned 40-18022 into my 5e3. The tube side wires are red, green and Yellow. Does anyone know to which (V3 & V4) the...