Separate names with a comma.
has anyone tried any of these "special purchase bodies" with the glued in necks from GFS?
It went very well!
I used a 4-way kit from ToneShaper. It did require using a dremel to enlarge the switch plate cavity a little bit so...
Thanks so much for everyone's suggestions. I found a good video that I think will help!
If I were to use Roger's method, I'd move them all out to 80-85% of their total possible extension and measure 25.5" from the FRONT edge of the...
If I'm using an offset saddle like this:
and going the top load approach...which one do I measure to since they are staggered?
FYI...the body and neck I'm using is from Solo Music Gear
Thank you! out of the entire project, I'm most nervous about getting the bridge right because it's so crucial. I should of purchased a kit that...
Thanks, Roger. Stupid question - what is the break point on the saddles? Thanks!!
Would this work for the body I have? I take it the slight difference in the volume/tone cavity doesn't matter?
I'm starting my first build and failed to realize that the '69 Thinline body I purchased has no markings for the bridge. Is there a template...