Separate names with a comma.
Strotosphere is good, they are near by me in Boston and they have had good turn around times in the last year or so. At least that's my experience.
I mark the 1/2 point of the shaft on all my bits and never extend them past that point. Because I had 1 bit, in a router table set up, while...
If you put a finish on it, although it looks open pore, it's still coated in finish so no impact or rather same a gloss.
Oh, now were talking a mash up of the 72' out there.
Would you be building the whole thing, or just the body?
I'd start with pricing out enough...
Pine isn't bad, it dents easily but with a rosewood or like fret board it's just as good as others, same with Doug Fir and Spruce. I find quarter...
- Maple (Hard, Soft and Roasted)
- Doug Fir
- Pau Ferro
Butternut - weight can very quite a bit but it's super easy to work. Takes stain nicely and can even do the sexy wood thing if you find the right...
I love the look of QS or Rift Sawn lumber but . . . when I build (especially necks) I tend to use the most seasoned and stable woods in the shop....
Les Paul's of any kind. Standard, Special, Custom, SG . . .blah
I love the look but have never bonded with one, even the vintage ones I've had a...
The Stew Mac finishing book and the Bob Flexner Wood Finishing 101 are good books on how to apply and prep for finish.
A tutorial on how to...
Anyone seen or heard from Rick lately?
Dude, that look great! Nice work!
That is awe . . .some!
Great exchange between nutslt and gbuilder, I laughed out loud!
What about an epoxy bath to make a rectangle block? Or cut it down the middle and...
Nice job! The volume knob is it push pull? or are the pickups on all the time?
I have a 92 G&L Legacy (I'm owner #2 in 95) and 95/96 G&L S500 custom order. These are still my main guitars but only because I haven't finished...
I make Maple Bacon Cheddar scones a few times during the winter and I always get a weird look until I get someone to try one . . . and then thy...
G&L was founded in 1979.
Maybe you should just clean up the hack job but leave the cavity?
Thinking about the OPs original questions.
Increased demand for sure! I'm paying more and waiting longer for the bobbins and magnets that I've...
They would mount either way but you would need wood screws to body mount and machine screws to pickguard and Tele bridge mount. The springs go...