Telecentric's Recent Activity

  1. Telecentric replied to the thread Thoughts on the Babicz FCH Tele Bridge? Considering Getting One.

    @moosie covered the ground location in his post. Most times it is soldered to either pot. As for the dangers of playing an ungrounded...

    Sep 18, 2019 at 1:24 AM
  2. Telecentric replied to the thread What gauge strings are on your Telecaster?.

    10's on my main tele, flatwound 12's on the slide Tele

    Sep 17, 2019 at 7:12 PM
  3. Telecentric replied to the thread Thoughts on the Babicz FCH Tele Bridge? Considering Getting One.

    There only seems to be one missing factiod for this thread. You would absolutely need to ground an aluminum bridge, and aluminum is a...

    Sep 17, 2019 at 6:58 PM
  4. Telecentric replied to the thread The Warmoth decal - do you use it?.

    I don't use the Warmoth decal because it is ugly, and only the neck is Warmoth. I don't put a Fender decal on it, because I don't want...

    Sep 13, 2019 at 5:53 PM
  5. Telecentric liked etype's post in the thread The Warmoth decal - do you use it?.

    I go decal-less. When people ask, I say no one put together exactly what I wanted so I had to do it myself.

    Sep 13, 2019 at 5:48 PM
  6. Telecentric replied to the thread Troubleshooting humming after pickup install.

    Just screw the bridge down on top of the wire (without insulation). The wood will compress, and the bridge will hold it in place. That's...

    Sep 13, 2019 at 5:43 PM
  7. Telecentric replied to the thread Diagnosing Tuner Peg issue.

    All tuners have a certain amount of gear lash, which is the dead band between turning in one, then the opposite direction. When I need...

    Sep 13, 2019 at 10:52 AM
  8. Telecentric replied to the thread What if your Tele turned into a Strat ....

    No thanks! I prefer a Tele to be a Tele, and a Strat to be a Strat. A tele with a trem, humbuckers or more than 2 singles just seems...

    Sep 12, 2019 at 2:14 PM
  9. Telecentric posted a new thread.

    Has anyone rolled the fingerboard edges on an unfinished roasted maple neck?

    I'm nervous to try. I know that roasted maple is brittle, so not sure if the screwdriver method is viable. I absolutely do not want to...

    Forum: Tele-Technical

    Sep 12, 2019 at 12:25 PM
  10. Telecentric replied to the thread Neck Pocket and Neck bolt hole Alignment.

    Sure. You can buy hardwood dowels at any hardware store. Get one slightly larger than the hole you need to fill, and drill out the bad...

    Sep 11, 2019
  11. Telecentric attached a file to the thread Troubleshooting humming after pickup install.

    From another thread here [ATTACH] Solder the other end of the wire to a ground point on a pot.

    images.jpg Sep 11, 2019
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.