Separate names with a comma.
Couldn't resist slapping a little spirits on there to see if any of that figuring was going to show through...
No too shabby
Well I guess this is gonna have to set over night. Little blow out inside the neck pocket when I was drilling for the neck screws
The long drill bit
Only hurt myself a little :oops:
Hoping to do a nice white blonde/Mary Kaye. Something that still shows off the grain a bit.
I don’t have a spray setup so I’m limited to white I...
If you mean the rear route, I just used a 1/2” router bit. For the deep route and the rebate.
Moved on to fretting (at some point during all this I drilled for the jack too)
This was my first time fretting. It seemed much more intimidating...
Let’s do this...
Primary facet done
Almost there. Just needs some dressing up. But I was pretty tired of rasping, filing,...
Made a template and routed the recess for the rear control plate
[ATTACH] [ATTACH] [ATTACH]
Not quite as clean as I would have wanted. But not...
You could always go with Tele-sized P-90s. I've used the Porter 9T set and absolutely love them.
My 2 cents...
I’ve built 2 parts teles with tauro bodies over the last year or so. Quality of both were fantastic. Great grain choice, invisible...
The onto headstock thinning and transition. Still need a little work in this area
And an ok repair for that fret board chipout
Today we gots dots
Good snug fit