Separate names with a comma.
I just bought these and used it on a neck. Great for the transitions. Still used a Shinto for the bulk removal.
I got one in the works as well. The body is finished, just waiting on some free time to carve the neck.
I’ll post a pic when (if?) I complete it.
What’s that body weigh?
If I were doing that, I’d thin a piece a maple down to .1, and then laser cut it. Sand a slight bevel on the edges and countersink the screw holes...
May be old news but I couldn’t find the post...
Looks like MJT guitars has purchased USACG and will be moving operations to Missouri.
Check out “rock lite” if your looking for more realistic looking wood substitute. LMI carries it. It’s lighter and has “grain”
Taylor is using 59x1 and 37x6 from simtec, both full UV cure
I was told from a vendor that fender uses UV cured fillers to get the base coat flat...
I use uv fillers all the time.
Key is thin coats. And remember, if it soaks into wood deeper than light can hit it, it will never cure.
Just call LMII
I have them resaw all kinds of wood that I supply them. As recently as 3 weeks ago.
They may not have that feature available on...
Looks pretty good
I agree with silver face on this one. Tests can be deceiving.
I’ve done this finish many times and I’ll say my success rate was 25%
Even when you...
It’s a real finish. No veneer. Solid mahogany.
I've got one somewhere I drew up on corel. Let me find it and I'll send it to you if you still need it
LMI nailed cheap osb plywood to the cement floor in their warehouse. They did it cause the forklifts were slipping on the wax from wood that’s...