Neck Building Question

Discussion in 'Tele Home Depot' started by Skip Ellis, Apr 17, 2013.

  1. Skip Ellis

    Skip Ellis Tele-Meister

    Posts:
    152
    Joined:
    Oct 2, 2006
    Location:
    Florida
    Can someone point me to a drawing or diagram showing the block with the angled hole that aligns the drill bit with the truss rod slot at the peghead? Also, is the block located at the point where the flat part of the peghead starts its curve up to the fingerboard? How far above the peghead surface is the angled hole started?
    Thanks!!!
     
  2. guitarbuilder

    guitarbuilder Doctor of Teleocity Silver Supporter

    Posts:
    19,872
    Joined:
    Mar 30, 2003
    Location:
    Ontario County
  3. jpbturbo

    jpbturbo Tele-Afflicted

    Posts:
    1,208
    Joined:
    Dec 30, 2010
    Location:
    Banner Elk, NC
  4. Shepherd

    Shepherd Friend of Leo's

    Posts:
    4,113
    Joined:
    Jan 17, 2008
    Location:
    Maple Ridge, Canada
  5. Colt W. Knight

    Colt W. Knight Doctor of Teleocity Ad Free Member

    Posts:
    18,871
    Joined:
    Jan 21, 2007
    Location:
    Tucson, AZ
IMPORTANT: Treat everyone here with respect, no matter how difficult!
No sex, drug, political, religion or hate discussion permitted here.


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.