Separate names with a comma.
I use a 3.0 Dunlop Tri Stubby.
I never thought I would like so heavy of a pick, but lately that is all I use.
I love TGI Fridays, especially the Jack Daniels chicken. (I dont drink but I do
like that JD marinade they use.)
I have done it a bunch of times, mainly on pine, a few times on ash.
I have never tried it on mahogany as the above poster has done, I am curious...
I want one!
He wont be there any time.
Once the current investment co, ownership extracts all the cash they can
from the company and gets business going a...
Are you sure that is not a factory finish?
Ed Sheeran plays one of those now, I bet the value is rising.
I don't see why he would lie- in the Carmine St. movie he says he uses shellac as the finish
on his custom guitars. Those are the guitars made...
You won't have a lot of choices if you can't spray.
I would do Min wax water based poly if you must brush.
Goes on smooth and no fumes.
I actually learned that years ago on the Reranch forum.
I use spray on canned shellac for this, and by flaw, I dont mean that it is...
Anyone can make a mistake- and maybe he was busy with finals, etc.
At this point either leave him a positive, or dont leave anything.
No need to...
I have done it hundreds of times without issue.
You are right in that it does not melt, but when correcting a bad flaw I don't want the flaw to...
I only liked Flip or Flop when they would have Christina test out the pool rehab in her bikini.
Then she starts to talk and I had to change the...
What I do when I get a large flaw is I sand it flat, then hit the area with a
coat of shellac, then proceed with the finishing and additional...
I just saw her last nite on a re-run of the Carol Burnett Show.
I was watching a show on AXS-TV a few years ago about music mysteries, and
I think he was jailed for child molestation or something like that
Those guitars are not any good anyway so I dont blame you for cutting it
Would you make my custom shop Gibson into a headless?
If the guitar is good I would leave positive feedback.
Or none at all.
That is what I would do.
That or a Pignose or Blackstar Fly 3.
That way if they get a bigger amp later, they will still have a micro amp
Pot meet kettle.
You are the one writing bull,,,,- you started at least one other thread which got shut down
because you didnt abide by the rules...
Why would it be a nightmare? It is not a Fender, once you accept that and
move on you can find something else.
You are putting out threads on...
You can flood the seams with superglue and then sand and polish and
then any movement of the stripe will be minimized or disappear.
A very fine tip oil based pen that you can buy at the craft store will cover up that long crack and make it close to invisible.