Asher Guitars WD Music Products Amplified Parts Mod Kits DIY Nordstarnd Pickups Warmoth.com
Asher Guitars WD Music Products Amplified Parts Mod Kits DIY Nordstarnd Pickups Warmoth.com
Asher Guitars WD Music Products Amplified Parts Mod Kits DIY Nordstarnd Pickups Warmoth.com

Phrygian77's Recent Activity

  1. Phrygian77 liked Bendyha's post in the thread Long tail vs cathodyne phase inversion... in non-technical terms..

    A long tail pair will tend to have a gain of somewhere around 53 using two halves of a 12xx7 tube A Cathodyne is normaly accompanied by...

    Nov 22, 2017 at 9:12 AM
  2. Phrygian77 liked corliss1's post in the thread Favorite tube socket brand/type?.

    The Beltons get all the love lately for new builds :D I've used tons of these with no issues.

    Nov 22, 2017 at 9:01 AM
  3. Phrygian77 replied to the thread eyelet board tips.

    I just go easy on the solder if I'm going to add a wire later. Tin the wire lightly, heat up the eyelet/joint, pop the wire in, and...

    Nov 18, 2017
  4. Phrygian77 liked Old Tele man's post in the thread The Ultimate Light Bulb Limiter.

    I, too, use a KILL-A-WATT™.

    Nov 18, 2017
  5. Phrygian77 replied to the thread The Ultimate Light Bulb Limiter.

    The Champ being single ended class A is consuming full power (or at least close to it) at idle. But, there's way more tubes with...

    Nov 18, 2017
  6. Phrygian77 replied to the thread The Ultimate Light Bulb Limiter.

    Anyway, the PR I built sounded great dimed, especially with the raw switch on and the NFB off. I tried to get some quick clips of it...

    Nov 18, 2017
  7. Phrygian77 replied to the thread The Ultimate Light Bulb Limiter.

    The gain is slightly less than unity I believe, but upping the voltage does increase the amount voltage it can swing before it runs out...

    Nov 18, 2017
  8. Phrygian77 liked Thin69's post in the thread Princeton Reverb Build.

    Great looking build. Nice job!

    Nov 18, 2017
  9. Phrygian77 liked Nickfl's post in the thread Princeton Reverb Build.

    Well, at least you have it narrowed down! ;)

    Nov 18, 2017
  10. Phrygian77 liked robrob's post in the thread Princeton Reverb Build.

    Your chassis looks fantastic, congrats.

    Nov 18, 2017
  11. Phrygian77 replied to the thread The Ultimate Light Bulb Limiter.

    With the original tubes, my PRII plate voltage was 405 and biased a bit high at 71% (not sure if 70% or so was stock, or if drifted up...

    Nov 18, 2017
  12. Phrygian77 replied to the thread Bassman aa864 clone hum and noise.

    2 volts is about right. Considering the plates are 290, which is bit high but not far off, the cathode voltages look about right to me.

    Nov 18, 2017