4 way wiring help

acoustic · May 13th, 2008, 08:25 PM

Greetings,

I have a partscaster which has the standard pickup setup in it. I wish to put a 4 way tele switch in,

I currently have a cap on the bridge pup at the switch to warm up that pickup a little.

The question - I assume when I install the 4 way switch that the cap will also affect the neck pup in the series position(?). Would there be any workaround that would prevent this? I would like to accomplish this without any additional switches/etc.

Any ideas are VERY much appreciated!

Thanks!

Mark Davis · May 13th, 2008, 11:42 PM

Welcome to the forum look over in the Tele Tech area there are lots of tips about 4 way switches.

May 13th, 2008, 08:25 PM	#1 (permalink)
acoustic NEW MEMBER! Join Date: May 2008 Location: Akron,Ohio Posts: 6	4 way wiring help Greetings, I have a partscaster which has the standard pickup setup in it. I wish to put a 4 way tele switch in, I currently have a cap on the bridge pup at the switch to warm up that pickup a little. The question - I assume when I install the 4 way switch that the cap will also affect the neck pup in the series position(?). Would there be any workaround that would prevent this? I would like to accomplish this without any additional switches/etc. Any ideas are VERY much appreciated! Thanks!

May 13th, 2008, 11:42 PM	#2 (permalink)
Mark Davis Doctor of Teleocity Join Date: Mar 2003 Location: Bakersfield Ca. Age: 58 Posts: 12,845	Welcome to the forum look over in the Tele Tech area there are lots of tips about 4 way switches. __________________ I'm so blind my seeing eye dog needs glasses.