 |
 |
|
| Supporting Vendors | ||||||
 |
 |
 |
 |
 |
 |
 |
| advertise on the tdpri | ||||||
|
||||||||||||||||||||||||
January 19th, 2010, 04:11 PM
|
#1 (permalink) |
|
Tele-Holic
Join Date: Jul 2009
Location: Wodbridge, VA
Age: 38
Posts: 821
|
Make my own threaded saddles
I am replacing my MIM Nashville fishman power tele bridge (anyone want it?) with one I am making from scratch. I was inspired by the Scattercaster $100 challenge. Does anyone know what size machine screw could be used as the base to make threaded saddles? I will likely use the saddle height and intonation screws from the exisiting setup, and plan to drill and tap the holes in the fashioned saddles as needed. Thanks.
|
|
|
 |
| Bookmarks |
| Thread Tools | |
|
|
|
|
IMPORTANT:Treat everyone here with respect, no matter how difficult! No sex, drug, political, religion or hate discussion permitted here.
The words Fender®, Telecaster®, Stratocaster® and the associated headstock designs are registered trademarks of the Fender Musical Instruments Corporation.
The TDPRI is an independent, member supported forum and is not affiliated with Fender Musical Instruments Corporation.
