 |
 |
|
| Supporting Vendors | ||||||
 |
 |
 |
 |
 |
 |
 |
| advertise on the tdpri | ||||||
|
||||||||||||||||||||||||
March 22nd, 2008, 12:12 PM
|
#1 (permalink) |
|
Poster Extraordinaire
Join Date: Jul 2007
Location: Virginia
Posts: 7,209
|
50's Mod for Esquire
OK so i've read about the 50's mod and I want to try it on my Esquire. I tried the cap/res vol kit and did'nt like it but I also don't like how the treble gets rolled off almost imediately when I roll the volume down. I think the 50's mod may be the way to go. My only question is do I un-solder the jack hot and then re-solder both the jack hot and a wire from the tone to the vol pot? Or can I just solder the wire underneath on the lug that the jack hot is soldered to? Here's how my Esquire is wired now:
|
|
|
 |
| Bookmarks |
| Thread Tools | |
|
|
|
|
IMPORTANT:Treat everyone here with respect, no matter how difficult! No sex, drug, political, religion or hate discussion permitted here.
The words Fender®, Telecaster®, Stratocaster® and the associated headstock designs are registered trademarks of the Fender Musical Instruments Corporation.
The TDPRI is an independent, member supported forum and is not affiliated with Fender Musical Instruments Corporation.
