Wiring help needed from Deaf Eddie or other wiring experts.

[sean79]

My project is getting closer to the wiring stage. At one point, I got some good ideas for the rewire, but I was hoping someone could help me out with a wiring diagram for what I want to do.

The neck humbucker is an Ibanez INF1 (it has a red, blue, white, and black wire - along with what looks like an uninsulated ground).

The bridge humbucker is an old Carvin from the late 80s (it has a red, white, and black wire - along with a braided metal sheathing that looks like it's soldered to the brass plate on the bottom of the pickup).

The guitar will have a 3-way toggle for pickup selection (neck/both/bridge) and a push/pull for volume and a push/pull for tone.

I want my volume knob to switch the buckers to singles when it's pulled out (probably a shunt [maybe a split]).

When the tone knob is pulled out, I want the pups to switch to in series/out of phase.

Can this all be done with the two pickups that have different numbers of wires? I've looked at different websites, including Deaf Eddies, but I still can't figure out how to do this. Any help would be appreciated.

Sean.

[Deaf Eddie]

I can help you out there. Send me an e-mail with a little more info about your axe and pups, I bet I can have a drawing for you in an hour or so...

[Johnny Caster]

Hey Eddie do you have any bigger pictures of that "gobstopper" strat in your signature? Looks neat.

[Deaf Eddie]

Here's the scan from Tony Bacon's book, Fuzz and Feedback:

Rocky!

[Johnny Caster]

Thanks!

[sean79]

Thanks for the offer. I sent you email with more information.
Sean.