 |
 |
|
| Supporting Vendors | ||||||
 |
 |
 |
 |
 |
 |
 |
| advertise on the tdpri | ||||||
|
||||||||||||||||||||||||
|
|||||||
| Burnt Fingers DIY Effects Building or modding your own Effects and Stompboxes? Then use this forum to discuss the process and show your pride and joy. |
 |
|
|
Thread Tools |
April 30th, 2012, 07:44 PM
|
#1 (permalink) |
|
Tele-Holic
Join Date: Jul 2009
Location: Wodbridge, VA
Age: 38
Posts: 786
|
1st time build, its a fuzz help
I have all the parts for a radio shack fuzz as listed in an instructables demo... but they don't show the layout... only the schamatic which I don't understand... here's the link to the instructsbles. If anyone can help me with this, I would be very greatful.
http://www.instructables.com/id/Fuzz-Pedal/ |
|
|
|
May 1st, 2012, 10:02 AM
|
#2 (permalink) |
|
TDPRI Member
Join Date: Feb 2012
Posts: 11
|
I normally use vero board but there is layouts at www.runoffgroove/sili-face.html. For experiment board. For a ff to sound right the two transistors are usually mid matched with q1 being a lower gain hfe than q2. Go to geofex.com and read technology of the fuzz face. It will work with the q1q2 being the same but better if not.
|
|
|
|
|
| Bookmarks |
| Thread Tools | |
|
|
|
|
IMPORTANT:Treat everyone here with respect, no matter how difficult! No sex, drug, political, religion or hate discussion permitted here.
The words Fender®, Telecaster®, Stratocaster® and the associated headstock designs are registered trademarks of the Fender Musical Instruments Corporation.
The TDPRI is an independent, member supported forum and is not affiliated with Fender Musical Instruments Corporation.
