dannyboy2.0
January 28th, 2008, 03:21 PM
Saw this in the Billy Gibbons clips, playing on of these, and the tone was great! Apparently just announced at NAMM, looks to be a limited run of 100 and they include SD BG Esquire pickup, with special switching (described below) - any idea how to duplicate this set-up?
http://www.fender.com/customshop/instruments/search.php?partno=9233000023
3-Position Blade with Custom Eldred-Esquire Wiring:
Position 1. Special Cap. Across Entire Pickup, (for )
Position 2. Volume Control with Cap. and Tone Control with Cap.
Position 3. Volume Control Only No Cap., No Tone Control
I know Shades is building an Esquire with a BG Esquire pickup and had a cool wiring diagram that sounds similar - not sure about the cap on the whole pickup (#1) and how to get no cap on vol. pot (#3). Is this wiring named after Mike Eldred of the Custom Shop maybe? Has it been used on other guitars in the past?
I want one of these hotties real bad so I am looking at selling a few guitars I can do without to finance one of these, probably in black to be opposite my blonde MIM Esquire reissue. But if I cant swing it, I hope to convert my MIM to match as close as possible... Any suggestions on the wiring would be appreciated!
Dano
http://www.fender.com/customshop/instruments/search.php?partno=9233000023
3-Position Blade with Custom Eldred-Esquire Wiring:
Position 1. Special Cap. Across Entire Pickup, (for )
Position 2. Volume Control with Cap. and Tone Control with Cap.
Position 3. Volume Control Only No Cap., No Tone Control
I know Shades is building an Esquire with a BG Esquire pickup and had a cool wiring diagram that sounds similar - not sure about the cap on the whole pickup (#1) and how to get no cap on vol. pot (#3). Is this wiring named after Mike Eldred of the Custom Shop maybe? Has it been used on other guitars in the past?
I want one of these hotties real bad so I am looking at selling a few guitars I can do without to finance one of these, probably in black to be opposite my blonde MIM Esquire reissue. But if I cant swing it, I hope to convert my MIM to match as close as possible... Any suggestions on the wiring would be appreciated!
Dano
![$vboptions[bbtitle]](../../gifs/tdpr-headTRANS.gif)