13/32 tuners?

Any recommendations for tuners that will fit headstock holes of this size?

13/32" (is that 10mm?)... a lot of online places don't say what size their tuners fit! Doh!

Budget is always a prime concern, but so is looks :)

Yes, that's 10 mm.

Google is helpful with conversion when you type 13/32 .in instead of 13/32 "
It confused me often enough.

You can always get conversion bushings if you go the Kluson way.

JC- I just put a set of Gotoh's in my 335 beater project. I was trying to cheap out too, IMHO the quality of (at least the lower end) Gotoh tuners have dropped in the past few yrs. I put the same set in another guitar a couple of yrs. ago and they are nice and tight. These new ones (same model # as the old ones) have all kinds of gear lash play, and feel sloppy. They hold tune OK (even with the Bigsby), but the sloppy feel just bugs the hell out of me. I'll be changing them out at some point. Maybe that's what I get for trying to cheap out. Just my $.02, YMMV.

- Jay

I believe most of the tuners in the Stew-mac and Grizzly catalogues are 13/32(10mm). Bought some for my project guitar, and then discovered I'll have to order a drill bit. No stores stock brad point 13/32 bits here.