Another boo boo question...rattle can poly

...was spraying rattle can gloss poly and it was getting close to the can being empty...a drop of poly sprayed out. Can I scrape it flat with a razor blade, or sand it flat? Whats the best way to deal with it??

Since most of the poly I'm familiar with advises sanding between coats, I'd think you could scrape off the worst of the blob, then sand the entire guitar, and shoot your next coat. Warm the rattle can in some hot water first, and although it is wasteful, save the last 1/4 can or so for jigs or templates, or some other application that isn't as critical.

although it is wasteful, save the last 1/4 can or so for jigs or templates, or some other application that isn't as critical.

Words to live by :wink:

Thanks guys!!!