Looking for 1 v 1 t tone 3 dpdt on/off toggle switch for hum and neck

Does anyone have a schematic for a 1 volume, 1 tone, humbucker bridge , single coil neck, 3 dpdt switches for neck on/off, bridge humbucker on/off, coil tap on/off. The switches have 6 contacts each. No 3 way switch. It's a 80s Japan contemporary model I picked up. The pickups were not attached and the wiring was a little messy but its all there. 1 tone cap. The humbucker has a 3 connection, sleeve ground wire, then 1 red and 1 white. The pickups are original and alnico (not that it makes a difference).

Thanks

Bump

First check the resistant on the wire to figure out if coiltapping is possible. Possible your humbucker can not be splitted.

Doesn't sound like your bucker is split wired.. It would have 5 wires, a green, a red, a black, a white, and a ground..