You it be safe to hook up all this stuff at once?

Here what I got in mind:

Fender 100w head into a weber Z matcher set for 4ohm from head to 16ohms for cab into one side of a Radial Headbone. For cleans.

Komet 19 head + Dr z Brake Lite. Setting Komet for 8 ohms going into Brake Lite then into the Headbone. The Dr, suggests using 8ohms into the Z attenuators.

I suppose I could use a 100w Air Break right after the Headbone but I never need to attenuate the Fender, I can get good cleans at any vol on that amp. The Komet needs to be craked though. I dunno its still on the table, havent bought the attenuator yet.

I finally decided on a Dr Z attenuator since its the same thing as a Komet attenuator and seem to work well with for light attenuation, and does not cost an arm n' a leg.


What do you guys think? Look safe? Well other than looking like the leaning tower of pisa if I tried to stack it all on top of each other on my vertical Port City cab.

I'll bump with questions.....
Are you using the same cab for both of these amps...coming out of the Headbone to select which amp is operable at any one time??? IF so, is that cab a 16 ohm cab? IF that is so, then does the Headbone take care of that
8 ohm into the 16 ohm cab as it does the 4 ohm/16 ohm thing for the Fender amp?? Just curious.....