![$vboptions[bbtitle]](../../gifs/tdpr-headTRANS.gif)
Zanman777
December 2nd, 2011, 05:18 PM
Hello! I need a piece of advice... Where (from what book/site/etc) can I learn the basics about tubes, electric circuitry and schematics to be able to tweak the modules on Peavey ReValver (the amp modeling software) having at least a clue of what I'm doing? :P
For who's not familiarized with this program, here are the screenshots of the concepts that matter on the program tweaking:
http://w2.myguitarshop.net/wp-content/uploads/2010/01/PRtweak1.jpg
http://blog.mixonline.com/briefingroom/wp-content/uploads/2009/03/tube-tweak.jpg
I'd like to be able to take an amp schematic, say...
http://support.fender.com/schematics/guitar_amplifiers/57_Deluxe_Fender_57_schematic.pdf
...and get the values I need from the schematic and put them on Peavey ReValver.
Where should I get introduced to this "electronic mess", then? :P
For who's not familiarized with this program, here are the screenshots of the concepts that matter on the program tweaking:
http://w2.myguitarshop.net/wp-content/uploads/2010/01/PRtweak1.jpg
http://blog.mixonline.com/briefingroom/wp-content/uploads/2009/03/tube-tweak.jpg
I'd like to be able to take an amp schematic, say...
http://support.fender.com/schematics/guitar_amplifiers/57_Deluxe_Fender_57_schematic.pdf
...and get the values I need from the schematic and put them on Peavey ReValver.
Where should I get introduced to this "electronic mess", then? :P