Looking for an esquire wiring diagram-with a twist...

Does anyone have an Esquire wiring diagram that will totally bypass the vol.and tone con trols in the bridge position- what I would like to wire her up is: neck pos. - cocked wah ( .010 cap. ) middle- standard vol. and tone controls, and bridge- wide open , straight to the amp ( no vol. or tone to cut signal output !!!) Does anyone have a diagram like this handy ??? ( finally finished the " elmsquire" just need to wire her up , and take for a test drive... !!!)

Mine is wired like that except I have volume and no tone in the back position...
For me it is the most useless of the 3 positions... I very rarely use position 3.

http://www.tdpri.com/forum/tdpri-2010-%24210-tele-build-challenge/201463-2010-tdpri-%24210-challenge-el-rey-de-cobre-4.html

I used the "Eldred diagram" except I chenged the .004 cap for a .001 and the .050 for a .047 because that is what I had.

1. Cocked Wah, Vol, no tone pot, fixed .001 cap
2. Vol and Tone .047 cap
3. Vol, no tone control (tone circuit bypassed)

http://www.tdpri.com/forum/attachments/tdpri-2010-%24210-tele-build-challenge/46768d1271402647-2010-tdpri-%24210-challenge-el-rey-de-cobre-esquire-eldred-jpg

Thanks for the diagram, Big Mike- will post pics of the " Elmsquire" later this weekend- she turned out beautiful !!! Thanks, again- GB