Wiring question: TV Jones Classic in a strat bridge

I have sent an email to TV Jones, but thought I'd get some input from here as well.

I have a strat clone (chambered ash body, with rosewood neck) with a TV Jones Classic currently wired into the bridge (500k pot, no cap/resistor). I have a neck and middle SD SSL-1 strat pups that I'd like to install along with a Fender superswitch. I got the superswitch so that I could get it wired for a B/BM/BN/NM/N set up. My thought is to wire it up with tone control on for the bridge, a tone control for the neck and middle and a master volume.

I was thinking 500k for the bridge tone and 250s for the Duncans and master volume. Is that the way to go when mixing sc and hums? What pots and cap and/or resistors should I use (if any)? I would like the bridge to go from an almost single coil brightness to crunch/middy humbucker.

Any suggestions or help would be great. I am going to a tech for the wiring and it would be great to walk in with instructions.

Thanks, Doug

http://www.tdpri.com/forum/just-pickups/193640-wiring-tele-p-90-neck.html#post2236251 is one way to mix-and-match.

-GB