Question for JWELLS393

Hi there.

I've just spotted a thread that you posted some time ago relating to grinding down the projecting screw hole arm on a Bigsby B5 and drilling a hole beneath the spring to mimic the closer mounting of the F-Style Bigsby.

I'm thinking of doing the same thing myself to increase the break angle.

You did a great job - very neat - I'm assuming you used a Dremel tool or similar.

In any case did you get to install that Bigsby in the end? and were there any stability issues if you did so? I'm wondering if the screw hole arm projection was originally manufactured like that for a reason?

Thanks for any replies.

Russ

Your chance of getting a response is much higher if you post on the tele home depot forum instead.

You might also look up his name on the member list (home page) and send him an email or a PM.

Here's his email.

jwells393@hotmail.com

Thanks for the replies.

I'll try on the other forum first I think.

Cheers!