tone mod on a squire

I have a squire strat with standard wiring:
5 way switch
SSS
separate tone for neck and middle PU
one volume

Is there any way to re wire it so the tone for the middle PU also controls the bridge PU

thank you

I know you can switch it so that it works on the bridge instead of the middle, but I'm not sure about controlling both.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tone_f_bp

I actually ditched one of the tone controls and moved the volume control to the middle hole and plugged the vloume control hole. The volume knob was always in the way when playing. My strat now has a basic one tone, one volume setup.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=3s_1v_1t_5w

>Is there any way to re wire it so the tone for the middle PU also controls the bridge PU <


On the side of the switch that the terminals are wired to the tone and volume controls, notice the terminal with nothing attached to it?

Wire a jumper wire from that terminal, to the one next to it (with the RED wire)


http://www.guitar-mod.com/wiring/standard_strat.gif

Thank you I will try that today.