|
|
|
||||||||||||||||||||||
|
|||||||
| Home | Forum | Resources | TeleShop | Gallery | Classifieds | Reviews | Register | FAQ | Search | Today's Posts | Mark Forums Read |
| Amp Central Station Amps, tubes, speakers & everything AMP related. |
|
|
Thread Tools |
|
|
#1 (permalink) |
|
Friend of Leo's
|
May need an amp tech
I've been using an old silver face champ for the last few years. It was bone stock, speaker and all, til this last summer, at which time, I replaced the stock speaker with a mojotone. After only a couple of months, the mojotone blew out. I went out and bought an over the counter replacement...jensen reissue. sounds ok. but now I'm noticing a funny gravely sound in the amp...It's not the speaker..as I've put the original back in to compare and the sound is still there.
The sound is kinda quiet, and easy to overlook, but consistently present. When I play a clear note, as its ringing out I can hear this low, gravely sound...almost like something grinding. Is it a tube going bad? Is something more serious wrong? What would cause the speaker to blow so quickly? ( I was playing close to dimed quite a bit) Possibly related?
__________________
"chips are falling....." -Dr. Johnny Fever |
|
|
|
|
|
#4 (permalink) |
|
Friend of Leo's
Join Date: Mar 2003
Location: The Gorge
Posts: 2,198
|
Filter cap's can do that as well if it is the sound I'm thinking of. I think of it as coffee percolating. Fortunately recapping a Champ can't be too very expensive. I'm just about to do my Pro Reverb which is just a little more involved and with pot cleaning I expect it will come home at about $100.
|
|
|
|
|
|
#5 (permalink) |
|
Tele-Meister
Join Date: Nov 2004
Posts: 229
|
It could also be...
... transformer interleaving. If you've changed speakers and the replacement is not as well matched it could have caused the output transformer to warm up and loosen laminates especially on an older tranny which probably has no resin on it right? If this is the case it's an easy fix... get some good strong zip ties and run them through the vacant holes in the transformer laminates (where bolts were never put by cheap-ass tranny builders) crank the ties shut and see if it goes away. If it does replace those zip ties with bolts when you have time.
pjb |
|
|
|
|
|
#6 (permalink) |
|
Friend of Leo's
|
I hope it is tubes...since I already have them on the way. amp should sound better even if that isn't the problem. thanks for the other tips.. if tubes don't do the trick I'll take it in and have it serviced.
__________________
"chips are falling....." -Dr. Johnny Fever |
|
|
|
|
|
#7 (permalink) |
|
Friend of Leo's
|
well, it was tubes...replaced the 6v6 (with a JJ 6V6 )and the 12ax7 (with a JJ ECC83S) and no more weird noise... except for the ones I'm making with the guitar.
The amp seems a little louder and has retained the tone I expect. thanks for the suggestions! ps-Bob @ eurotubes was really helpful....and fast. I ordered them Sunday night...I received them today, Wednesday.
__________________
"chips are falling....." -Dr. Johnny Fever |
|
|
|
| Bookmarks |
| Thread Tools | |
|
|
The words Fender®, Telecaster®, Stratocaster® and the associated headstock designs are registered trademarks of the Fender Musical Instruments Corporation.
The TDPRI is an independent,member supported forum and is not affiliated with Fender Musical Instruments Corporation.