Telecaster Guitar Forum - View Single Post

acoustic · May 14th, 2008, 06:45 PM

As a rookie on the forum I posted this by mistake in the general discussion board...I repost it here and thank the responder who suggested I check this forum!

Greetings,

I have a partscaster which has the standard pickup setup in it. I wish to put a 4 way tele switch in,

I currently have a cap on the bridge pup at the switch to warm up that pickup a little.

The question - I assume when I install the 4 way switch that the cap will also affect the neck pup in the series position(?). Would there be any workaround that would prevent this? I would like to accomplish this without any additional switches/etc.

Any ideas are VERY much appreciated!

Thanks!

May 14th, 2008, 06:45 PM	#1 (permalink)
acoustic NEW MEMBER! Join Date: May 2008 Location: Akron,Ohio Posts: 6	4 way wiring help As a rookie on the forum I posted this by mistake in the general discussion board...I repost it here and thank the responder who suggested I check this forum! Greetings, I have a partscaster which has the standard pickup setup in it. I wish to put a 4 way tele switch in, I currently have a cap on the bridge pup at the switch to warm up that pickup a little. The question - I assume when I install the 4 way switch that the cap will also affect the neck pup in the series position(?). Would there be any workaround that would prevent this? I would like to accomplish this without any additional switches/etc. Any ideas are VERY much appreciated! Thanks!